Operation Manual IQ-BASIC-GPS 20
Bräuniger GmbH
3.3.3.2 Keypad functions in Menu Edit
After calling the Menu Edit WP the 1st letter of the
WP-name will blink. Using the keys and the
required letter is selected, there are numbers, letters,
as well as a set of special characters to choose from.
Using the keys you move to the next or
previous letter.
The key A-a-1-& alloys to shift between capital and small
type letters as well as the case shift and special
characters.
By prolonged pressure on the same key one single
character is deleted (Rub out).
The name may contain max. 16 charcters.
On the middle and bottom row the position of WP has to
be entered. In the middle the latitude is prompted
(North or South) and on the bottom line the longitude –
(East or West).
Once the entry of one row is completed, it is saved
by pressing the OK key and the cursor skips to the next
row.
3.3.3.3 Delete all WP
Pressing the OK key on the position Delete all WP enables the delete
function. For data safety the IQ-BASIC-GPS prompts once again:
„delete all WP?“. By use of the OK key the deletion can be confirmed,
or it can be cancelled with the ESC key and return is performed to
the previous level.
Tip: by use of the PC-Software „Flychart 4.52“ Waypoints can be set
easily and comfortablyon the computer for transmission via PC-interface
to the instrument.
Remark:
the more Waypoints are saved in the memory, the more slowly the navigation becomes in
Main Setup Menu, as the list is rearranged again in the background over and over.
3.3.4 Goto–Function
By use of the Goto function it is possible to navigate to a
certain waypoint at anytime, even when a Route is active. The
Goto function is activated by prolonged pressure on the key
WP and brief pressure on the F1 key. This function allows for
searching a waypoint stored in the memory of the IQ-BASIC-
GPS using the or key and to activate it with the OK key.
Remark: at first position of the WP-list is always listed the
Last Thermal.
After activation shall appear In the compass rose the
arrow to the Goto waypoint.
An active Goto-function can be deactivated with the
F1 key ( Canc Goto).
Tip: on page 3 = Navigation the distance and the direction to the
Goto waypoint shall be indicated!
To Next Page
Loading...
