Breas Z1 - Page 5

5
Doc. HD40-0007-02 En-Eu L-4
WARNINGS:
• Before use, make sure the power cord and plug are in good condition and that the
cord is not damaged.
• Do not use bleach, chlorine, alcohol, or aromatic-based solutions, moisturizing or
antibacterial soaps or scented oils to clean your Z1, Power Supply, PowerShell or
Battery. These solutions may create a shock hazard, cause damage and reduce the
life of these items.
• Explosion Hazard — Do not use or store your Z1, Power Supply, PowerShell or
Battery in the vicinity of ammable anesthetics or oxygen.
• Do not use your Z1 near toxic or harmful vapors.
• Do not drop your Z1 or any of its accessories or expose it to any crushing forces.
Should your Z1 be dropped and fail to operate properly, contact Breas or your
health care provider before using the Z1 for treatment.
• Do not insert any object into any tubing or opening of your Z1 except as described
in this User Guide.
• Do not operate your Z1 in any area which may block its air intake. Blocking the
CPAP Tube and/or air inlet of your Z1 while in operation could lead to overheating
of the Z1.
• If you put the Z1 on the oor, make sure the area is free from dust and clear of
bedding, clothes or other objects that could block the air inlet or cover the Power
Supply unit.
• Only store or transport the Z1 and accessories within the storage and transport
temperature, humidity and altitude conditions specied in the Technical
Specications section of this User Guide.
• Do not operate your Z1, Power Supply, PowerShell or Battery in an area which may
cause overheating.
• Do not cover the Power Supply, PowerShell or Battery with any object or material
which would cause them to overheat.
• Keep the power cord, Power Supply, Battery and Z1 away from hot or ammable
surfaces, gases or materials.
• Do not open your Z1 or tamper with its accessories. There are no user serviceable
parts inside. Repairs and servicing should only be performed by an authorized
Breas service agent.
• Only power the Z1 with the Z1 Power Supply (AC-to-DC power adapter) or the
optional Z1 PowerShell with Breas Medical Battery. Do not use any other AC
adapters, batteries, or other power sources to power the Z1. Do not use the Z1
Power Supply, PowerShell or Battery to power any device other than the Z1.
• Your Z1 should only be used with standard CPAP air tubing as recommended by
your physician, clinician or health care provider.
• Do not leave long lengths of air tubing around the top of your bed. The tube could
twist around your head or neck while you are sleeping.