Brent 1082/882 — Set Up
2-4
Basic Set Up (continued)
SMV Emblem
SMV Emblem
Before the cart is used the refl ective surface
of the SMV must face rearward. This may re-
quire removal of fi lm protecting the refl ective
surface or removing and reinstallation of the
SMV. When reinstalling the SMV make sure
that it is mounted with the wide part of the
SMV at the bottom.
Auger Rest Retainer Removal
Remove the retainer located on the upper auger
rest at the back of the cart, before folding out
the upper auger tube.
• Upper auger retainer must be removed before
operating upper auger tube. Failure to remove
retainer will result in damage to the upper
auger tube.
(May 2015)
To Next Page
