Brent 1082/882 — Set Up
2-14
Optional Weather Guard Tarp Installation (continued)
7. (2-person operation) On a clean fl oor, lay the tarp out fl at with the raw edge of the hems and pockets
down and the exterior side facing up.
8. Insert the small 1 1/8” tube (221588) by sliding it into the small pocket of the tarp. Leave 1” of the
tube sticking out one end and drill a 3/16” hole through the center of the outer reinforcement strap
and tube. Fasten with a rivet (9003378). At the other end, pull on the tarp by hand to stretch it until
there is 1” of tube sticking out. Drill hole and install rivet. Press the 1 1/8” plugs (9005088) into each
end of the tube. See fi gure 7.
INSTALLATION TIP: Tarp is designed to be stretched the length of the tube to reduce wrin-
kling. For easier assembly, apply liberal dusting of baby powder on tube and inside of tube
pockets before sliding tubes in pockets.
9. Insert the 2” roll tube into the large pockets, with the splined shaft to the rear. Measure 10 1/2”
from the end of the spline to the start of the tarp. Install the fi rst U-clamp (9004949) and self-drilling
screws (9005197) to the fi rst reinforcement strap,to secure the tarp to the tube. Work down the roll
tube putting the U-clamps and self-drilling screws on each reinforcement strap. Make sure to keep
the tarp pulled tight to reduce wrinkling. See fi gure 7.
Model 882 ONLY, mount tarp defl ectors approximately 6” in from ends (see parts pages
for additional information). Grain carts with any unused holes on the side of the cart need
to be plugged. Use pre-drilled 1/8” locator holes in the right-hand side of the cart. Install
with 1/4” self-tapping screws and nuts provided. Locate the 3rd defl ector near the center of the cart,
also using pre-drilled holes and same hardware.
Fig. 7
(July 2013)
To Next Page
Loading...
