Brent 1082/882 — Operation
3-5
Transport Position
Parked
Position
Hitching to Tractor
Drawbar Connection
This cart is intended to be hitched to a tractor drawbar. Do not attempt to hitch to any other location
on the tractor other than the drawbar.
The cart is equipped standard with a single tang hitch. A hitch pin between 1 1/2” or 2”
diameter must only be used with a clevis-type tractor drawbar. An optional hammer strap
is available if your tractor has a single tang drawbar.
NOTE: The use of a smaller diameter hitch pin will result in additional clearance between
the hitch and pin. This additional clearance may cause accelerated pin wear, tractor and cart
hitch wear, along with more pronounced jolting from the cart during transport operation.
• DO NOT STAND BETWEEN THE MACHINE AND TRACTOR WHEN HITCHING. ALWAYS
ENGAGE PARKING BRAKE AND STOP ENGINE BEFORE INSERTING HITCH PIN.
After inserting drawbar pin, secure drawbar pin with a locking device to help prevent uncoupling
during use.
Jack Usage
• UNHITCHING A LOADED CART CAN CAUSE SERIOUS INJURY OR DEATH DUE TO
THE TONGUE RISING OR FALLING. ALWAYS HAVE A LOADED CART ATTACHED TO A
TRACTOR. THE JACK IS INTENDED TO SUPPORT AN EMPTY CART ONLY.
• Mount jack in storage location indicated after cart is hitched to tractor.
(August 2012)
To Next Page
Loading...
