27
CONTROL PANEL MESSAGES – ERROR DETECTION
When the Start button is pressed to begin the program and there is a problem relating to the
sensor, the bread machine will beep twice and then flash an error message specific to the
problem.
There are 4 different messages.
If the error messages EEE or HHH appear in the Display Window contact your nearest
authorized Breville Service Centre (Refer Page 33).
CONTROL PANEL MESSAGES
26
ERROR MESSAGE PROBLEM CORRECTION
E01 If attempting to use Press Stop to reset.
the bread machine Open the lid and remove
shortly after a loaf the bread pan to cool.
has been baked, its Always allow the bread
interior will still be machine sufficient time
warm, i.e. the sensor to cool before using again.
temperature will still
be above 40ºC.
E00 The ambient temperature Ensure the room temperature
is too cold. is above 10°C.
To Next Page
Loading...
