Optional Fine Chop Kit
The Bale King 5300 processor has an optional fine chop knife kit (BMI # 32117) available to go
into the lower tub area. This option is available if you require a finer cut on the material which
you are processing such as slough hay and silage bales.
It is recommended that the knives be lowered when bedding straw as it will affect your
spread pattern. Adjust the machine as needed.
There are two settings for the fine chop, depending on how fine you wish to cut the
material. These settings achieved by pulling on the handle (towards the back of the machine), then
selecting the desired hole.
To Next Page
Loading...