Pressure Washer Rinsing
For Rinsing:
1. Remove black detergent spray tip from nozzle
extension.
2. Select and install desired high pressure spray tip
following instructions How to Use Spray Tips.
3. Keep spray gun a safe distance from area you
plan to spray.
4. Increase (decrease) spray pressure by
turning pressure control knob (
A) clockwise
(counterclockwise). Use lower pressure to wash
items such as a car or boat. Use higher pressure
to strip paint and degrease driveways.
5. Apply a high pressure spray
to a small area and
then check surface for damage. If no damage
is found, you can assume it is okay to continue
rinsing.
6. Start at top of area to be rinsed, working down
with same
overlapping strokes as you used for
cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must
ush it with clean water before stopping the engine.
1. Place detergent siphoning tube/lter in a bucket
full of clean water.
2. Remove high pressure spray tip from nozzle
extension.
3. Select and install black detergent spray tip
following instructions How to Use Spray Tips.
4. Flush for 1-2 minutes.
5. Shut o engine following instructions How to Stop
Pressure Washer and turn o water supply.
6. ALWAYS point spray gun in a safe direction,
press red button and squeeze spray gun trigger to
release retained high water pressure.
Automatic Cool Down System (Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the
spray gun, circulating water in the pump can reach
temperatures above 125°-155°F (51°-68°C). The
system engages to cool the pump by discharging the
warm water onto the ground.
A
WARNING Kickback from spray gun could
cause you to fall resulting in death or
serious injury.
• Operate pressure washer from a stable surface.
•
Be extremely careful if you must
use the pressure washer
from a ladder, scaolding, or any other similar location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks
back.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.
To Next Page
Loading...
Need help?
Pressure and Flow
