16 BRIGGSandSTRATTON.COM
Troubleshooting
Problem Cause Correction
No pump output or
low pump output when
water pump is running.
1. Pump not primed. 1.
Fill pump chamber with water and prime pump.
2. Suction hose restricted, collapsed,
damaged, too long, or diameter too small.
2. Replace suction hose.
3. Strainer not completely under water. 3. Sink the strainer and the end of suction hose
completely under water.
4. Air leak at suction hose connector. 4. R
eplace sealing washer if missing or
damaged. Tighten hose connector and clamp.
5. Strainer clogged. 5. Clean debris from strainer.
6. Discharge hose restricted, damaged, too
long, or diameter too small.
6. Replace discharge hose.
7. Excessive or marginal head. 7.
Relocate pump and/or hoses to reduce head.
8. Engine speed lever is in “Slow” position. 8. Move engine speed lever to “Fast” position.
Engine will not start;
lacks power; starts and
runs rough; or “hunts”
or falters.
1. Rocker switch set to “Off”. 1. Set switch to “On”.
2. Fuel shutoff is in “Off” position. 2. Turn fuel shutoff to “On” position.
3. Dirty air cleaner. 3. Clean or replace air cleaner.
4. Out of fuel. 4. Wait two minutes and fill fuel tank.
5. Stale or contaminated fuel or water in fuel. 5.
Drain fuel tank and carburetor; fill with fresh fuel.
6.
Spark plug wire not connected to spark plug.
6. Connect wire to spark plug.
7. Bad spark plug. 7. Replace spark plug.
8. Excessive fuel is present in the air/fuel
mixture causing a “flooded” condition.
8. Wait 5 minutes and re-crank engine.
9.Carburetorisoutofadjustment. 9.ContactAuthorizedservicefacility.
Engine shuts down
when running.
Out of fuel. Wait two minutes and fill fuel tank.
To Next Page
Loading...
Need help?
General
