Brillcam Inc. Copyright 2020-2021 Page 64 , Total 83
3.5.4 Video loss
The user can select the “Video loss” tab to set the parameters of the video loss alarm of the device. Video
loss means the NVR failed to get the stream or video signal from the channel.
• Channel: it allows the user to select the channel to set the motion detection parameters.
• Alarm mode: it allows the user to selec the alarm triggerd action mode from full screen, email or beep
when there is motion detected.
• Linage: it allows the user to set the channel linkage.
• Copy: it allows the user to copy the settings to other channels.
• Apply: it allows the user to apply the settings.
• Cancel: it allows the user to cancel the settings.
There will be alarm notification window promoted when there is video loss triggered as below.
To Next Page