93
BRINKLEY CUSTOMER CARE: phone: 888.502.3460 or 574.501.4280 / email: CustomerCare@BrinkleyRV.com
SAFERIDE 24/7 - EMERGENCY ROADSIDE ASSISTANCE: 888.482.5715 / Customer Service: 855.963.1770
IMPORTANT: The actuator is prepared
for manual override.
• DO NOT disengage the motor at any time.
• Simply apply the crank to the override
and begin to crank.
2. Maintenance
The slide-out mechanism is designed for minimal
maintenance. Operate each slide-out once or
twice a month to keep the seals and all other
internal moving parts lubricated and flexible.
• The best operation of a slide-out system
requires the auxiliary battery to be fully charged.
• Inspect for loose, corroded, or damaged
components at the battery terminals, control
switch, and slide motor.
• When operating the slide-out system in harsh
environments (i.e., road salt, environmental salts,
ice buildup, under trees, etc.) keep all moving
parts clean and clear of debris.
- Remove all ice buildup and other debris.
- Dry all water that is collected.
- Wash as needed with mild soap
and water and then dry.
•
Apply dry, non-silicone-based lubricants as needed.
For additional maintenance instructions, please
refer to the
Lippert’s Electric Through Frame
Slide-Out System Service Manual
.
3. Service and Adjustments
• Every 90 days, slide-out rooms should be
inspected to ensure proper function of the
slide and its related seals.
• Every 6 months, slide-out rooms should
be adjusted and inspected by a certified
RV service technician.
• Any adjustments made by non-certified
person or entity may void the warranty.
E. LIPPERT IN-WALL SLIDE-OUT SYSTEM -
SLIM-RACK
1. General Information, Extending, and Retracting
Another slide system utilized by Brinkley RV is
the Lippert SlimRack® system. Unlike a through
frame that passes through the RV chassis, this
system is mounted to the wall structure.
Note that it is normal for slide-outs to make
noises such as squeaking or creaking while being
operated. These noises are more common during
the “break in period” of the RV and will continue
until components and materials are seated
properly. After a few uses, this noise will lessen.
The SlimRack system has two gear racks on either
side of the slide room.
The controller for the SlimRack Slide-Out system
is located in the bulkhead storage compartment.
If you experience issues with your Slim Rack,
Lippert’s troubleshooting guide will require
you to review this controller for error codes.
To Next Page
Loading...
General