BRIO Signature Series User Manual

Cleaning the POU cooler
Cleaning the POU cooler reservoir
1. Disconnect power cord from outlet.
2. Remove top of cooler and inner oat assemby to expose the cold tank below.
3. Drain reservoir through the cold water (light blue) faucet and the hot water
(red if you have a hot and cold water cooler) faucet into a bucket and throw
that away. If there is ice in the reservoir, allow to melt and then drain. You can
add hot water to speed up the melting. If you have a hot & cold water cooler,
then drain the hot tank via the plug on back of water cooler.
4. Clean cooler exterior & faucets with hot water and mild soap. Dry with paper
towels.
5. Remove the water guard or spill-free top from your water cooler. Remove the
bae inside the reservoir as well. Both should just pull right out, depending
upon the model cooler you have. Also remove (by unscrewing) the spigots on
the front of the water cooler. If you have a removable reservoir water cooler
then you can also take that out at this time.
6. Wash these with mild dish soap and water. Rinse with clean water and set
aside. If you removed the reservoir then reinstall that rst. Screw the faucets
back on to the front of the water cooler.
1. For hot & cold water coolers you must plug the hot tank o. You can do this
with a small cork or plug. It must be tight and t right in the center hole in
the bottom of the water cooler's reservoir. This prevents the sanitizer from
getting into your hot tank -- if bleach gets into the hot tank, your hot water
will taste like chlorine for quite a while. The hot tank sanitizes itself since it's
very hot.
2. mix one gallon of clean water and one teaspoon of unscented bleach. Put on
your clean rubber gloves and dip a clean, lint-free towel into the solution and
wring out the excess liquid. Towel down clean all of interior surfaces of the
reservoir thoroughly. Let that chlorine solution stay in the cooler for about 5
minutes.
3. Sanitize spill-free top and bae by wiping them down with the towel lled
with the sanitizing solution. You don't need to soak them, just wipe them.
Allow to sit for at least 3 minutes and then rinse thoroughly with clean
bottled water, and set aside.
4. Fill reservoir full of fresh bottled water and completely drain that water
through the cold faucet. Repeat twice. That makes three (3) times total, and
uses about three (3) gallons of bottled water.
5. Put on a clean pair of rubber gloves and take out the hot tank cork (if you put
one in), replace the bae and spill-free top assembly by pressing them rmly
back into place. You shouldn't have any chlorine taste. If you do, keep
draining more water until the chlorine taste disappears.
6. Plug the cooler back in. It might take thirty minutes or so before the water is
hot and/or cold again.

BRIO Signature Series Specifications

General

Brand	BRIO
Model	Signature Series
Category	Water Dispenser
Language	English