Versa-Tether
®
24
4
Hook the tether to an anchor point.
•
See figure A for forward-facing installation.
•
See figure B for rear-facing installation. Rear-racing
installation may also require use of the Tether Connector
Strap, as described on page 25.
5
Pull the adjuster strap to remove all slack.
6
Verify that there is tension in the tether strap and that child
restraint is properly secured.
NOTE:
•
The rear-facing recline angle of the child restraint should not
exceed 45º from vertical.
•
The rear-facing recline angle can be adjusted by tightening the
tether as described in figure B, using anchor point 3.
•
It may be necessary to loosen the tether and vehicle seat belt
before adjusting the recline position.
Using the Rear-Facing Tether Connector Strap
IMPORTANT: Only use the tether connector strap (Fig. C) for rear-
facing tether installation. Because every vehicle model is different,
sometimes you cannot find a location to properly anchor the tether,
or the structural part of the seat is too large for the hook. Use the
tether connector strap to assist in creating an anchor point.
BA
To Next Page
Loading...
