Versa-Tether
®
25
1 Find a fixed vehicle seat belt anchor or
vehicle seat leg that is bolted to the floor
that the strap can be wrapped around.
2 Loop the strap around the metal anchor
(Fig. C).
3 Take the metal D-ring and thread it
through the webbing loop on the other
end of the strap.
4 Pull the metal D-ring all the way through
until the strap is tight around the metal
anchor.
5 Use the D-ring as an attachment point
for the hook on the tether strap. Refer to
pages 23–24 for instructions on using the
tether.
WARNING: THE TETHER HAS BEEN
DESIGNED TO INDICATE WHEN THE
CHILD RESTRAINT HAS BEEN IN A
SEVERE CRASH AND REPLACEMENT OF
THE CHILD RESTRAINT IS NECESSARY.
• Figure D shows the tether when the child restraint is
acceptable for continued use. The colored stitching will be
intact and the webbing will be looped inside the shell.
• Figure E shows the tether when the child restraint is
unacceptable for continued use. The colored stitching will be
broken and the loops will have pulled through the backside
of the shell. If this condition occurs, discontinue use of the
child restraint and contact Britax Child Safety, Inc. Consumer
Services for further instruction.
D
E
C
To Next Page
Loading...
