Specifications subject to change without notice. © 2013 Brivis Climate Systems Pty Ltd
5
1.3 Codes / Regulations
Brivis ICE units must be installed, serviced or repaired in accordance with these instructions and related regulations, codes,
standards, and authorities. These include but may not be limited to:
• Ozone Protection and Synthetic Greenhouse Gas Management Regulations 1995
• AS/ NZS 1677.2 - Australian Standard, Refrigeration systems, safety requirements for fixed applications
• AS 4211.3 Gas recovery or combined recovery and recycling equipment
• HB 276-2004 : A Guide to Good Practice for Energy Efficient Installation of Residential Heating, Cooling & Air
Conditioning Plant & Equipment
• AS 4254 - Ductwork for air-handling systems in buildings
• Local Electricity Authority
• Local Building Regulations
• Environment Authorities
• Building Code of Australia (BCA)
• Brivis “SuperSizeGuide”
It is recommended the Brivis “SuperSizeGuide” be followed in estimating cooling requirements and for system design that
will result in efficient installation and provide a higher level of comfort and economical operation.
Brivis assumes no responsibility for equipment installed in violation of any code or regulations and these installation
instructions.
2.0 Components
Upon receiving units, inspect for damage and ensure appliances match your order. In the event of damage, or incorrect delivery, notify
supplier immediately. Brivis accepts no responsibility for installation of damaged or incorrect units.
2.1 Indoor Unit (Cooling Coil)
Remove packaging from unit and any protective foam packing from coils and pipes. Indoor units are shipped with a holding
charge of dry nitrogen. Check to confirm the holding charge. For lifting details refer to the General Arrangement drawings.
• Brivis ICE indoor coil units shall be installed only downstream of a heater
• Brivis ICE is not designed for installation on a marine craft, houseboat, or any similar environment.
Fig. 1 - Indoor Cooling Coil
DI-XU18Z
Access Plate
P-Trap
DI-XU22Z
Access Plate
P-Trap
To Next Page
Loading...
