53-1004408-11 Installation Guide
Brocade
®
G610 Switch Hardware Installation Guide
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device as shown in the following figure.
2. Insert two 8-32 x 5/16-in. screws into one of the pairs of vertically aligned holes in the bracket and then into the vertical
pair of holes on the side of the device. To install the device in a recessed position in the rack, use the bracket holes
that are set back from the end of the bracket.
3. Insert 8-32 x 5/16-in. screws through the rest of the holes in the bracket and into the corresponding holes in the
device.
4. Repeat step 1 through step 3 to attach the left front bracket to the left side of the device.
5. Tighten all of the 8-32 x 5/16-in. screws to a torque of 15 in.-lbs (17 cm-kgs).
Figure 4: Attaching the Front Brackets
1. Bracket, Front Right
2. Screw, 8-32 x 5/16-in. Panhead Phillips
NOTE
Install the device with the airflow aligned with any other devices in the rack. Some devices have airflow
running from the port side to the fan side, and others have the opposite arrangement. Make sure that the
airflow for all devices is in the same direction to maximize cooling.
53-1004408-11
21
To Next Page
Loading...
