Broadcom G610 - Introduction; About This Document; Supported Hardware and Software; Notes, Cautions, and Danger Notices

53-1004408-11 Installation Guide Brocade
®
G610 Switch Hardware Installation Guide
Introduction
About This Document
This hardware installation guide contains procedures and safety requirements for installing the Brocade
®
G610 Switch
into a rack system or as a stand-alone device. Also provided are steps to initially configure the switch for operation, verify
and monitor operation, replace switch field-replaceable units (FRUs), and install transceivers and cables. Complete
technical specifications for the switch are also included.
Supported Hardware and Software
This document is applicable to the Brocade G610 FC Switch running Fabric OS
®
(FOS) 8.1.0 or later. The following table
lists the rack mount kits that are supported with this device.
Table 1: Rack Mount Kits
Part Number Description
XBR-R000162 Fixed-mount kit for four-post racks.
XBR-000165 Mid-mount kit for two-post racks.
XNA-000072 Nonport-side fixed-mount rack kit (15 in.—20 in.) for four-post racks.
Notes, Cautions, and Danger Notices
Notes, cautions, and danger statements may be used in this document.
NOTE
A Note provides a tip, guidance, or advice, emphasizes important information, or provides a reference to related
information.
CAUTION
A Caution statement alerts you to situations that can be potentially hazardous to you or cause damage to
hardware, firmware, software, or data.
DANGER
A Danger statement indicates conditions or situations that can be potentially lethal or extremely hazardous to
you. Safety labels are also attached directly to products to warn of these conditions or situations.
53-1004408-11
6
Broadcom