53-1004408-11 Installation Guide
Brocade
®
G610 Switch Hardware Installation Guide
Brocade G610 Switch Technical Specifications
The following tables highlight the features and specifications for the Brocade G610 Switch.
System Specifications
System Component Description
Enclosure 1U, nonport-side intake airflow, port-side power inlet.
Power inlet C13; power from the port side.
Power supplies Single, fixed power supply.
Fans Four built-in fans.
Cooling Nonport side to port side.
System architecture Nonblocking shared memory switch.
Port-to-port latency < 900 ns with no contention (destination port is free) including FEC using cut-through frame
switching.
Fibre Channel Ports
System Component Description
Fibre Channel ports 24 SFP+ ports (8-port increments through capacity-based Ports on Demand [PoD] licenses that
support any combination of short wavelength [SWL], long wavelength [LWL], or extended long
wavelength [ELWL] optical media).
The SFP+ ports are capable of auto-negotiating to 4, 8, 16, or 32G speeds depending on the SFP+
model and the minimum supported speed of the optical transceiver at the other end of the link.
•
4, 8, and 16G performance is enabled by 16G SFP+ transceivers provided that the other end of
the connection has a minimum of 4G speed set on the port.
•
8, 16, and 32G performance is enabled by 32G SFP+ transceivers provided that the other end of
the connection has a minimum speed of 8G set on the port.
2, 4, and 8G transceivers are not supported.
ANSI Fibre Channel protocol Fibre Channel Physical and Signaling Interface standard (FC-PH).
Modes of operation Fibre Channel Class 2 and Class 3.
Fabric initialization Complies with FC-SW-3 Rev. 6.6.
Fibre Channel over IP (FCIP) Complies with FC-IP 2.3 of the FCA profile.
Port status Bicolor LED (amber/green).
Other Ports
System Component Description
Serial console port One three-wire (Tx, Rx, Gnd) UART serial port.
Ethernet management port One 1000/100/10Mb/s Ethernet port.
USB port One external USB port.
53-1004408-11
57
To Next Page
Loading...
