53-1004408-11 Installation Guide
Brocade
®
G610 Switch Hardware Installation Guide
Complete the following steps to attach the rear brackets to the front brackets.
1. Position the right rear bracket inside the right front bracket.
2. Attach the brackets using four 6-32 x 1/4-in. screws as shown in the following figure.
3. Adjust the brackets to the rack depth and tighten the 6-32 x 1/4-in. screws to a torque of 9 in.-lb (10 cm-kg).
4. Repeat step 1 through step 3 to attach the left rear bracket to the left front bracket.
Figure 17: Attaching the Rear Brackets to the Front Brackets
1. Bracket, Front Left
2. Bracket, Rear Left
3. Screws, 6-32 x 1/4 in. Panhead Phillips (four per side)
53-1004408-11
37
To Next Page
Loading...
