New PIM commands (Continued)TABLE 20
Command Note
Clear command
clear ipv6 multicast pimsm-snooping Clears PIM6 SM snooping information
Modified PIM commands TABLE 21
FastIron 08.0.xx FastIron 07.4.00 Note
Global level command
[no] hello-timer seconds
default: 30 secs
allowed range: [10 -3600]
secs
[no] hello-timer seconds
default: 60 secs
allowed range: [10 -3600]
secs
Configures the hello timer. The default value has
been changed.
[no] nbr-timeout seconds
default: 105 secs
allowed range: [3 - 65535]
secs
[no] nbr-timeout seconds
default: 180 secs
allowed range: [60 - 8000]
secs
Configures the PIM neighbor timeout value. The
default value and the allowed range have
changed.
[no] prune-wait seconds
default: 3 secs
allowed range: [0 - 30] secs
[no] prune-wait seconds
default: 3 secs
allowed range: [0 - 3] secs.
Configures the PIM prune wait timer. The allowed
range has changed.
[no] message-interval
seconds
default: 60 secs
allowed range: [10 - 65535]
secs
[no] message-interval
seconds
default: 60 secs
allowed range: [1 - 65535]
secs
Configures the message interval. The allowed
range has changed.
[no] hardware-drop-disable
Default: PMRI is enabled.
[no] hardware-drop Configures Passive Multicast Router Insertion
(PMRI). PMRI is now enabled by default.
[no] rp-address address [acl-
num | acl-name]
[no] rp-address address
[std-acl-num [override]]
Configures static RP using ACL.
FastIron 07.4.00 supports only standard
numbered ACL, whereas in FastIron 08.0.xx, all
ACLs (standard, extended, numbered, and
named) are supported.
In FastIron 07.4.00, an RP address learned from
the Bootstrap protocol takes precedence over
static RP, so the override option was provided to
give precedence to static RP. In FastIron 08.0.xx,
static RP takes precedence.
Appendix A: Changes Between Releases
48 FastIron Ethernet Switch Software Upgrade Guide
53-1003632-02