The following example is for an IPv6 VRRP Backup.
device# show ipv6 vrrp
Total number of VRRP routers defined: 26
Interface ethernet ve52
auth-type no authentication
VRID 52
state backup
administrative-status enabled
version v3
mode non-owner(backup)
priority 101
current priority 20
track-priority 20
hello-interval 100 msec
dead-interval 0 msec
current dead-interval 300 msec
preempt-mode true
ipv6-address 2001:DB8::52:3
virtual mac address 0000-5E00-0103
advertise backup: enabled
next hello sent in 00:00:36.5
master router 2001:DB8::768e:f8ff:fe33:8600 expires in 00:00:00.2
track-port 2/1/3-4/1/4(down) v41(up)
For Owner VRRP:
The following example is for a VRRP-E Master.
deviceshow ip vrrp-extended
Total number of VRRP-Extended routers defined: 50
Interface ethernet ve201
auth-type simple text password
VRID 201
state master
administrative-status enabled
priority 220
current priority 220
hello-interval 1000 msec
dead-interval 0 msec
current dead-interval 3100 msec
preempt-mode true
virtual ip address 10.201.201.5
virtual mac address 0000.00d7.82c9
advertise backup: enabled
next hello sent in 00:00:00.1
backup router 10.201.201.4 expires in 00:02:45.2
backup router 10.201.201.3 expires in 00:02:47.6
track-port 1/1/25-2/1/24(up)
To display information for an IPv6 VRRP Owner, enter the show ipv6 vrrp command at any level of the CLI.
device#show ipv6 vrrp
Total number of VRRP routers defined: 25
Interface ethernet ve52
auth-type no authentication
VRID 52
state master
administrative-status enabled
version v3
mode owner
priority 255
current priority 255
track-priority 5
hello-interval 1000 msec
ipv6-address 2001:DB8::52:3
virtual mac address 0000-5E00-0103
advertise backup: disabled
next hello sent in 00:00:00.1
backup router 2001:DB8::224:38ff:fec8:5a40 expires in 00:02:03.1
Displaying VRRP and VRRP-E information
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 545
To Next Page
Loading...
Need help?
General
