1-4
SECTION 1
DESCRIPTION AND SPECIFICATIONS
The IC-250-3E is a self-propelled Industrial Crane designed for material handling and maintenance
and repair of equipment, with special features of self-loading cargo decks, 4-wheel steer, and front-
wheel drive (4-wheel drive optional). The basic unit consists of a chassis and hydraulic boom
assembly. The chassis includes a frame, four hydraulic independently controlled outriggers,
engine, torque converter, powershift 4-speed transmission, front planetary drive/steer axle and rear
steer-only axle, fuel tank, hydraulic tank, control station, power steering and dual power brakes.
The boom assembly includes a hydraulic powered continuous rotation turret, proportional 4-section
telescopic boom, hydraulic boom elevating cylinder, hydraulic boom telescope cylinder and
hydraulic powered hoist. Rated Capacity Limiter (RCL) is standard.
IC-250-3E:
4-section hydraulically extended boom with capacity of 36,000 pounds (16330kg) at a 6-foot
(1.8m) load radius. Horizontal reach of 50.1 feet (15.27m) and vertical reach of 60.6 feet
(18.47m).
General:
Length:
Overall 23.5 feet (7.16m)
Chassis 15.4 feet (4.72m)
Width: 7.8 feet (2.39m)
Height:
Overall 7.9 feet (2.41m)
Deck 47 inches (1.19m)
Wheelbase: 100 inches (2.54m)
Ground Clearance:
Chassis 13 inches (33cm)
Minimum (Tailpipe) 10 inches (25cm)
Angle of Approach: 25 degrees
Angle of Departure: 24 degrees
Outriggers:
Spread 14.7 feet (4.50m)
Penetration 3 inches (76mm)
Boom Movement:
Rotation Continuous
Elevation 0 to 75 degrees
Telescope 34.5 feet (10.52m)
Boom Speeds:
Rotation 1.3 RPM
Elevation 22 seconds
Telescope 41 seconds
To Next Page
Loading...
