ATP_ASP Price Computing Scales Operation Manual Rev:Y2,August,2020
3.2 Installation
Remove transport lock from bottom of the scale base
Place the scale on a level surface
Install the stainless steel pan to the four hole on top of housing
3.3 Leveling
The scale is equipped with a level indicator located back side of scale
Use the adjustable leveling feet located on the bottom of the scale until the
bubble appears in the center of the scale.
3.4 Power Connection
Connect the adaptor pin in to the adaptor jack.
Adaptor jack is locating below the right side of the scale.
Adaptor connects into your AC power socket. Plugable equipment must be
installed near an easily accessible socket outlet with a protective ground/
earth contact.
3.5 Rechargeable battery operation
Note: Please charge the battery before using the scale for the first time.
The symbol above on BATT appears. scale of the weight display indicates that
the battery is getting low. it’s time to charge the battery with the AC power. If
scale goes on being used without proper charging, <BAT-LOW> words will
flicker on the display.
To Next Page
Loading...