BROMECH ATP ASP - Charging Battery; Battery Maintenance

Rev:Y2,August,2020 ATP_ASP Price Computing Scales Operation Manual
- 4 -
 Approximately 30 minutes of instrument usage are left; afterwards it will
shut off automatically.
 Please use the supplied battery charger for charging the battery
immediately,or scale cannot be used.
3.5.1 Charging Battery
 To charge the battery insert the adaptor pin to jack, jack is locating below the
scale. Adaptor simply plug into the mains power. The scale no needs to be
turned on.
 The battery should be charged for 12 hours for full capacity.
 Left side of the Total Price display there is an LED to indicate the status of
battery charging. When the scale is plugged into the mains power the
internal battery will be recharged. If the LED is green, the battery has a full
charge.
 If it is red, the battery is being charged.
 Do not use any other type of power adaptor than the one supplied with the
scale.
 Verify that the AC power socket outlet is properly protected.
3.5.2 Battery maintenance
 Recharge battery should be changed in every three months when not in use.
 If the scale is not used for an extended period of time,remove the battery from
the battery compartment to avoid leakage.
 Store the battery in a sealed bag or box in a dry, temperate environment.