Serger Badge: Brother 1034D
Age: Grade 9-Adult
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
● Threading the right needle (pink):
1. Open the front cover by sliding to the right and opening toward you.
2. Pull the thread from the spool and up through the hole on the thread guide on the
thread tree above the spool from back to front.
3. Pull thread about an extra six (6) inches through the front of the hole.
4. Pass thread through proper thread guide at top of machine (pink).
5. Slide and hold thread tension release button to the right, then pass thread
through tension disc in the channel next to the pink tension adjustment dial. Then
release the button.
6. Guide the thread down the channel and pass thread through the pink threading
points 5-7 (see p. 22 in manual for illustrations of threading points).
7. Put thread through the eye of the right hand needle and pull to the back.
[Insert diagram from p. 22 here]
● Threading the left needle (yellow):
1. Open the front cover by sliding to the right and opening toward you.
2. Pull the thread from the spool and up through the hole on the thread guide on the
thread tree above the spool from back to front.
3. Pull thread about an extra six (6) inches through the front of the hole.
4. Pass thread through proper thread guide at top of machine (yellow).
5. Slide and hold thread tension release button to the right, then pass thread
through tension disc in the channel next to the yellow tension adjustment dial.
Then release the button.
6. Guide the thread down the channel and pass thread through the yellow threading
points 5-7 (see p. 24 in manual for illustrations of threading points).
7. Put thread through the eye of the left hand needle and pull to the back.
[Insert diagram from p. 24 here]
5. Setting thread tension, differential feed, stitch
length, stitch width, and stitch type
● Thread tension:
1. From left to right:
To Next Page
Loading...
