3. INSTALLATION
8
BAS-341H, BAS-342H
3-6. Installing the gas spring
1. Tilt back the machine head, and then secure the support lever (1) at stopper position (a).
(Refer to "3-5. Tilting back and returning the machine head".)
NOTE: Use equipment such as a crane or hoist to tilt back the machine head.
2. Tighten the two set screws (2) to secure the support lever shaft (3).
3. Install the gas spring (8).
(4) Gas spring holders [L and R]
(5) Spacer
(6) Bolt
(7) Nut
(8) Gas spring
(9) Shaft collars [2 pcs.]
(10) Gas spring shaft D
(11) Plain washers [2 pcs.]
(12) Retaining rings E [2 pcs.]
(13) Bolts [4 pcs.]
(14) Plain washers [4 pcs.]
(15) Spring washers [4 pcs.]
(16) Nuts [4 pcs.]
(17) Gas spring shaft U
(18) Set screw
* After installing the gas spring (8), gently
return the machine head to its original
position.
(Refer to "3-5. Tilting back and returning
the machine head".)
Engaging
the stopper
Disengaging
the stopper
3466B
Crane or hoist
2915B
Note that the L and R
shapes are different.
Be sure to install so that
the side with “UP” on it is
facing upward.
To Next Page
Loading...
