To Next PageTo Next PageWhat to do if my Brother DCP-1616NW says 'Document Jam (For ADF models)'?
If your Brother All in One Printer displays 'Document Jam (For ADF models)', it means the document was not inserted or fed correctly, or the document scanned from the ADF was too long. Pull the jammed paper out of the ADF unit.
What to do if my Brother DCP-1616NW shows 'Out of Memory'?
If your Brother All in One Printer displays 'Out of Memory', it means the machine's memory is full. You can either press Start to send or copy the scanned pages, or press Stop/Exit and wait for other operations to finish before trying again. If printing, pressing Stop/Exit will cancel the print job and clear it from the memory. Alternatively, try lowering the print quality.
How to fix 'Cartridge Error' on Brother DCP-1616NW All in One Printer?
If your Brother All in One Printer displays a 'Cartridge Error', it indicates an issue with the toner cartridge. Make sure the toner cartridge is correctly installed in the drum unit, and then place it back into the machine. Also, ensure that you are using a genuine Brother toner cartridge and a Brother Original drum unit.
What does 'Toner Low' mean on my Brother DCP-1616NW?
If your Brother All in One Printer shows 'Toner Low', it means the toner cartridge is nearing the end of its life. Although you can still print, it's recommended to order a new Brother toner cartridge now. This ensures a replacement is available when the LCD shows 'Replace Toner' or 'Toner Ended'.
How to improve poor sending quality on Brother DCP-1616NW All in One Printer?
If you are experiencing poor sending quality with your Brother All in One Printer, try changing the resolution to Fine or S.Fine. You can also try cleaning the scanner.
How to resolve 'Size mismatch' error on Brother DCP-1616NW?
If your Brother All in One Printer displays 'Size mismatch', it means the paper in the tray is not the correct size. Load the correct size of paper into the tray and then set the paper size accordingly.
Why are sent faxes blank from my Brother All in One Printer?
If your Brother All in One Printer is sending blank faxes, ensure you are loading the document correctly. When using the ADF or scanner glass, the document should be placed face down.
What does 'Self-Diagnostic' mean on Brother All in One Printer and how to fix it?
If your Brother All in One Printer shows 'Self-Diagnostic', it could be due to the fuser unit's temperature. Turn the machine off, wait a few seconds, and then turn it back on. Leave the machine idle for 15 minutes with the power on.
Why are there vertical black lines when sending faxes from my Brother DCP-1616NW?
If you see vertical black lines when sending faxes from your Brother All in One Printer, it's typically caused by dirt or correction fluid on the glass strip.
General| Functions | Print, Copy, Scan |
|---|---|
| Print Technology | Laser |
| Print Speed (Black) | 20 ppm |
| Print Resolution | 2400 x 600 dpi |
| Scan Resolution | 1200 x 1200 dpi |
| Copy Speed (Black) | 20 cpm |
| Copy Resolution | 600 x 600 dpi |
| Monthly Duty Cycle | Up to 10, 000 pages |
| Paper Capacity | 250 sheets |
| Memory | 32 MB |
| Duplex Printing | Manual |
| Scanner Type | Flatbed |
| Supported Operating Systems | Windows, macOS, Linux |
| Connectivity | USB, Wi-Fi |
| Display | LCD |
| Paper Size | A4, Letter, Legal |
