Brother DCP-1623W

To Next Page

To Previous Page

2-242-24

 Confidential Confidential

 

7.7.4.4.11 CICIS uS uninit / t / CICIS fS flalat ct cabablele

(1)(1) RemovRemove the two (foe the two (four for modeur for models withols without ADF unit) tut ADF unit) taptite baptite bind B M4x12 sind B M4x12 screws to rcrews to removeemove

the scanner top cover ASSY from the document scanner unit.the scanner top cover ASSY from the document scanner unit.

(2)(2) RemovRemove the CIS role the CIS roller holdler holder L ASSY and the CIer L ASSY and the CIS roller hoS roller holder R ASSY frolder R ASSY from the CIS unim the CIS unit.t.

(3)(3) Open thOpen the CIS unit 13e CIS unit 130 degrees a0 degrees and slide it tnd slide it to the direco the directions of thtions of the arrow 3a ae arrow 3a and 3b tond 3b to

remove it from the CIS carriage ASSY.remove it from the CIS carriage ASSY.

(4)(4) DiscoDisconnect nnect the Cthe CIS flaIS flat cabt cable frole from the m the CIS uCIS unit.nit.

(5)(5) ReleaRelease the CIS flase the CIS flat cable frt cable from the secuom the securing fixring fixtures, antures, and remove id remove it from the dot from the documentcument

scanner unit.scanner unit.

Fig. 2-18Fig. 2-18

Harness routing: Refer toHarness routing: Refer to ““66.. Document scanner unitDocument scanner unit””andand ““77.. Panel flat cablePanel flat cable””..

Assembling Note:Assembling Note:

•• After After the the replacreplacement, ement, refer refer toto "3.

"3. IF YOU IF YOU REPLACE THE DOCUMENT REPLACE THE DOCUMENT SCANNER UNITSCANNER UNIT

OR CIS UNIT" in chapter 3OR CIS UNIT" in chapter 3to enter the adjusted value of the laser unit.to enter the adjusted value of the laser unit.

•• When removWhen removing the scanning the scanner top coverer top cover, ADF bevel gear ASSY wi, ADF bevel gear ASSY will come offll come off. When. When

assembling the scanner top cover, make sure that the ADF bevel gear ASSY isassembling the scanner top cover, make sure that the ADF bevel gear ASSY is

assembled.assembled.

Taptite bind B M4x12Taptite bind B M4x12

(only for models without(only for models without

ADF unit)ADF unit)

CIS roller holder L ASSYCIS roller holder L ASSY

CIS roller holder R ASSYCIS roller holder R ASSY

CIS flat cableCIS flat cable

Document scanner unitDocument scanner unit

Scanner topScanner top

cover ASSYcover ASSY

3a3a

3b3b