77..1122 SSiidde e ccoovveer r LL
(1)(1) Open the puOpen the pull-arm all-arm about 135 debout 135 degrees and pgrees and pull it up to reull it up to remove it fromove it from the side com the side cover L.ver L.
(2)(2) RemovRemove the three te the three taptite baptite bind B M4x12 sind B M4x12 screws. Rcrews. Release thelease the three hooe three hook bushingk bushings of thes of the
side cover L. Pull out the three tabs and release the four hooks on the bottom. Disconnectside cover L. Pull out the three tabs and release the four hooks on the bottom. Disconnect
the hook PCB harness from the hook harness (only for models with handset), and removethe hook PCB harness from the hook harness (only for models with handset), and remove
the side cover L from the machine.the side cover L from the machine.
(3)(3) Remove thRemove the taptie taptite bind B M4xte bind B M4x12 screw12 screw, and relea, and release the hook ose the hook of the dress cof the dress cover L tover L to
remove it from the side cover L.remove it from the side cover L.
Fig. 2-34Fig. 2-34
Taptite bind B M4x12Taptite bind B M4x12
HookHook
Taptite bind BTaptite bind B
M4x12M4x12
TabTab
Side cover LSide cover L
HooksHooks
TabsTabs
Taptite bind B M4x12Taptite bind B M4x12
Hook PCB harnessHook PCB harness
(only for models with handset)(only for models with handset)
Pull-armPull-arm
Dress cover LDress cover L
Hook harnessHook harness
(only for models(only for models
with handset)with handset)
135°135°
Hook bushingHook bushing
HookHook
bushingsbushings
To Next Page
Loading...
