Brother DCP-1623W - Page 124

2-362-36
 Confidential Confidential
 
7.7.1111 TTop op ccovover er AASSSSYY
(1)(1) RemovRemove the tapte the taptite cup B M3xite cup B M3x8 screw to re8 screw to remove the tomove the top cover locp cover lock from the mak from the machine.chine.
(2)(2) OpeOpen tn the he top top covcover Aer ASSYSSY..
(3)(3) Bend the boBend the boss bushiss bushing on the devng on the develop joielop joint link innt link inward to remward to remove it froove it from the guide rm the guide rail onail on
the top the top cover ASSY.cover ASSY.
(4)(4) Open the tOpen the top cover ASSY aop cover ASSY about 30 degbout 30 degrees and rerees and remove the bomove the boss on the arss on the arm side of them side of the
top cover ASSY by pushing it to the direction of the arrow 4a. Slide the top cover ASSY totop cover ASSY by pushing it to the direction of the arrow 4a. Slide the top cover ASSY to
the direction of the arrow 4b to remove the boss on the other side, and remove it by pullingthe direction of the arrow 4b to remove the boss on the other side, and remove it by pulling
up.up.
(5)(5) Remove Remove the pthe paper staper stopper opper from thfrom the top e top cover AScover ASSYSY..
(6)(6) RemovRemove the pe the paper saper stopper topper 2 from 2 from the top the top cover cover ASSYASSY..
Fig. 2-33Fig. 2-33
Note:Note:
•• Opening top coOpening top cover ASSY more than 30 degver ASSY more than 30 degrees could marees could make rib of the top coverke rib of the top cover
ASSY coming in contact with the fuser unit, resulting in damage.ASSY coming in contact with the fuser unit, resulting in damage.
Guide railGuide rail
Paper stopperPaper stopper
Paper stopper 2Paper stopper 2
ArmArm
BossBoss
Taptite cup B M3x8Taptite cup B M3x8
Top cover lockTop cover lock
BossBoss
Top cover ASSYTop cover ASSY
Boss bushingBoss bushing
BossBoss
Develop joint linkDevelop joint link
Guide railGuide rail
4a4a
4b4b
Laser shutter arm bossLaser shutter arm boss