Error code 7100Error code 7100
The eject sensor remains ON (paper pass detected) even after the paper printing positionThe eject sensor remains ON (paper pass detected) even after the paper printing position
sensor detected the end of paper pass.sensor detected the end of paper pass.
Jam Inside 2Jam Inside 2
Open the Scanner Cover and remove the jammed paper, then Open the Scanner Cover and remove the jammed paper, then press Start.press Start.
<User Check><User Check>
•• RemRemove thove the jamme jammed paed paperper..
•• Check thaCheck that the paper is set in the pt the paper is set in the paper tray coraper tray correctlyrectly..
•• Check thaCheck that there is not too muct there is not too much paper set in the pah paper set in the paper trayper tray..
•• Flip over the pFlip over the paper in the papaper in the paper tray or rotater tray or rotate the paper 180 dege the paper 180 degrees.rees.
•• Check thaCheck that the thicknet the thickness of the paper is wiss of the paper is within the stthin the standardandard..
•• Flip throFlip through the paugh the paper and resper and reset it in the paet it in the paper trayper tray..
SStteepp CCaauussee RReemmeeddyy
11
Foreign object in the rear of theForeign object in the rear of the
machinemachine
Remove the foreign object.Remove the foreign object.
22
Eject actuator caught inEject actuator caught in
sections of the machinesections of the machine
Reattach the eject actuator.Reattach the eject actuator.
33
Paper feed/paper printingPaper feed/paper printing
position sensor PCB failureposition sensor PCB failure
Replace the paper feed/paper printing positionReplace the paper feed/paper printing position
sensor PCB ASSY.sensor PCB ASSY.
44 EEjjeecct t sseennssoor r ffaaiilluurree RReeppllaacce e tthhe e eejjeecct t sseennssoor r PPCCB B AASSSSYY..
55 MMaaiin n PPCCB B ffaaiilluurree RReeppllaacce e tthhe e mmaaiin n PPCCB B AASSSSYY..
To Next Page
Loading...
