Brother DCP-1623W

1-341-34
 Confidential Confidential
 
1 31 3
C fC f

Error code 7300Error code 7300
The paper feed sensor does not detect paper pass even after the paper has been fed for theThe paper feed sensor does not detect paper pass even after the paper has been fed for the
specified time.specified time.
Jam TrayJam Tray
Remove the jammed paper from Tray, then press Start.Remove the jammed paper from Tray, then press Start.
<User Check><User Check>
•• RemRemove thove the jamme jammed paed paperper..
•• Check thaCheck that the paper is set in the pt the paper is set in the paper tray coraper tray correctlyrectly..
•• Check thaCheck that there is not too muct there is not too much paper set in the pah paper set in the paper trayper tray..
•• Flip over the pFlip over the paper in the papaper in the paper tray or rotater tray or rotate the paper 180 dege the paper 180 degrees.rees.
•• Check thaCheck that the thicknet the thickness of the paper is wiss of the paper is within the stthin the standardandard..
•• Check thaCheck that the size ot the size of the papef the paper is withir is within the stann the standard.dard.
•• Flip throFlip through the paugh the paper and resper and reset it in the paet it in the paper trayper tray..
SStteepp CCaauussee RReemmeeddyy
11
Foreign object in the front of theForeign object in the front of the
machinemachine
Remove the foreign object.Remove the foreign object.
22
Gears around the plate up plateGears around the plate up plate
coming offcoming off
Reattach gears around the plate-up plate.Reattach gears around the plate-up plate.
33 Attachment failure of the motorAttachment failure of the motor
drive beltdrive belt
Reattach the motor drive belt.Reattach the motor drive belt.
44
Attachment failure of the laserAttachment failure of the laser
shutter armshutter arm
Reattach the laser shutter arm.Reattach the laser shutter arm.
55
Connection failure of the mainConnection failure of the main
motor harnessmotor harness
Reconnect the main motor harness.Reconnect the main motor harness.
66
Connection failure of the motorConnection failure of the motor
encoder PCB flat cableencoder PCB flat cable
Reconnect the motor encoder PCB flat cable.Reconnect the motor encoder PCB flat cable.
77
Connection failure of the pick-Connection failure of the pick-
up solenoid harnessup solenoid harness
Reconnect the pick-up solenoid harness.Reconnect the pick-up solenoid harness.
88 MMoottoor r eennccooddeer r PPCCB B ffaaiilluurree RReeppllaacce te thhe e mmoottoor r eennccooddeer r PPCCB AB ASSSSYY..
99
Low voltage power supply PCBLow voltage power supply PCB
failurefailure
Replace the low voltage power supply PCBReplace the low voltage power supply PCB
unit.unit.
1100 LLaasseer r uunniit t ffaaiilluurree RReeppllaacce e tthhe e llaasseer r uunniitt..
1111 MMaaiin n PPCCB B ffaaiilluurree RReeppllaacce e tthhe e mmaaiin n PPCCB B AASSSSYY..