Installing the Driver & Software
22
STEP 2
Macintosh
Macintosh
Wired
Network
4
For Wired Network Interface Users (DCP-7045N only)
For Mac OS X 10.2.4 or greater
Make sure that you have finished the
instructions from step 1 Setting Up the
Machine on pages 8 through 11.
1 Plug the AC power cord into an AC outlet. Turn
the power switch on.
2 Connect the network interface cable to the
machine, and then connect it to your network.
3 Turn on your Macintosh.
4 Put the supplied CD-ROM for Macintosh into
your CD-ROM drive.
5 Double-click the Start Here OSX icon to install.
Follow the on-screen instructions.
• Please see the Network User’s Guide on the CD-
ROM to install the PS driver.
• Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart to finish installing the software.
To Next Page
Loading...
