Brother DCP-7060D - 3 Loading Documents; How to Load Documents; Using the Automatic Document Feeder (ADF) (for DCP-7065 DN)

21
3
3
How to load
documents 3
You can make copies and scan from the
ADF* (Automatic Document Feeder) (*For
DCP-7065DN) and the scanner glass.
Using the automatic
document feeder (ADF)
(For DCP-7065DN) 3
The ADF can hold up to 35 pages and feeds
each sheet individually. Use standard 80 gsm
paper and always fan the pages before
putting them in the ADF.
Document Sizes Supported 3
How to load documents 3
IMPORTANT
• DO NOT leave thick documents on the
scanner glass. If you do this, the ADF may
jam.
• DO NOT use paper that is curled,
wrinkled, folded, ripped, stapled, paper-
clipped, pasted or taped.
• DO NOT use cardboard, newspaper or
fabric with the ADF. Instead use the
scanner glass.
• To avoid damaging your machine while
using the ADF, DO NOT pull on the
document while it is feeding.
Note
• To scan documents that are not suitable
for the ADF, see Using the scanner glass
(Flatbed) on page 22.
• It is easier to use the ADF if you are
loading a multiple page document.
• Make sure documents with correction fluid
or written with ink are completely dry.
a Lift up and unfold the ADF document
output support flap (1).
Unfold the ADF document support (2).
b Fan the pages well.
c Place your document face up top edge
first, in the ADF until the LCD display
message changes and you feel it touch
the feed rollers.
Loading documents 3
Length: 147.3 to 355.6 mm
Width: 147.3 to 215.9 mm
Weight:
64 to 90 gsm
(2)
(1)