Brother DCP-9270CDN - Setting up and Changing the Public User Mode

Chapter 2
6
Changing the password 2
a Press MENU.
b Press a or b to display
General Setup.
Press General Setup.
c Press a or b to display
Function Lock.
Press Function Lock.
d Press Set Password.
e Enter the registered four-digit password
by pressing the buttons on the
Touchscreen.
Press OK.
f Enter a four-digit number for the new
password by pressing the buttons on the
Touchscreen.
Press OK.
g Re-enter the password when the LCD
shows Verify.
Press OK.
h Press Stop/Exit.
Setting up and changing the
Public user mode 2
Public user mode restricts the functions that
are available for Public users. Public users do
not need to enter a password to access the
features made available through this setting.
You can set up one Public user.
a Press MENU.
b Press a or b to display
General Setup.
Press General Setup.
c Press a or b to display
Function Lock.
Press Function Lock.
d Press Setup ID.
e Enter the administrator password by
pressing the buttons on the
Touchscreen.
Press OK.
f Press a or b to display Public.
Press Public.
g Do one of the following:
 To set up the Public user, press
Enable or Disable for each
operation, as follows: Press Copy.
Then press Enable or Disable.
After you have set Copy, repeat
these steps for Scan,
Direct Print, Print and
Color Print.
 To change the Public user settings,
press a or b to display the setting you
want to change. Press the setting
and press Enable or Disable.
Repeat this step until you finish
changing settings.
h Press Stop/Exit.