Brother DCP-9270CDN - Turning Secure Function Lock On;Off

Chapter 2
8
h To change the password, enter a new
four-digit user password by pressing the
buttons on the Touchscreen.
Press OK.
i To change a restricted user's settings,
press a or b to display the setting you
want to change. Press the setting and
then press Enable or Disable.
Repeat this step until you are finished
making changes.
j Press Stop/Exit.
Note
You cannot use the same name as
another user's name.
Reset existing restricted users 2
a Press MENU.
b Press a or b to display
General Setup.
Press General Setup.
c Press a or b to display
Function Lock.
Press Function Lock.
d Press Setup ID.
e Enter the four-digit administrator
password by pressing the buttons on the
Touchscreen.
Press OK.
f Press a or b to display the existing
restricted user you want to reset.
Press the user name.
g Press Reset.
h Press Yes to reset the existing restricted
user.
i Press Stop/Exit.
Turning Secure Function
Lock on/off 2
Turning Secure Function Lock on
a Press MENU.
b Press a or b to display
General Setup.
Press General Setup.
c Press a or b to display
Function Lock.
Press Function Lock.
d Press Lock OffiOn.
e Enter the registered four-digit
administrator password by pressing the
buttons on the Touchscreen.
Press OK.
Turning Secure Function Lock off
a Press Public or xxxxx on the LCD.
(Where xxxxx is the user's name.)
b Press Lock OniOff.
c Enter the registered four-digit
administrator password by pressing the
buttons on the Touchscreen.
Press OK.
Note
If you enter the wrong password, the LCD
will show Wrong Password. Re-enter
the correct password.