Brother DCP-9270CDN - 4 Making Copies; How to Copy; Copy Settings; Stop Copying

27
4
4
How to copy 4
The following steps show the basic copy
operation. For details about each option, see
Advanced User's Guide.
a When you want to make a copy, press
(COPY) to illuminate it in blue.
 Make sure you are in Copy mode.
 The LCD shows:
You can enter the number of copies
you want by pressing the + and -
buttons on the Touchscreen.
b Do one of the following to load your
document:
 Place the document face up in the
ADF. (See Using the automatic
document feeder (ADF) on page 25.)
 Load your document face down on
the scanner glass. (See Using the
scanner glass on page 26.)
c Press Mono Start or Colour Start.
Note
If the LCD shows Please Wait and the
machine stops copying while you are
making multiple copies, please wait for 30
to 40 seconds until the machine finishes
the colour registrations and cleaning
process of the belt unit.
Stop copying 4
To stop copying, press Stop/Exit.
Copy settings 4
Press COPY and then press d or c to choose
the setting you want. For details about
changing the copy settings, see Copy
settings in Chapter 4 of the Advanced User's
Guide.
You can change the following copy settings:
 Quality
 Enlarge/Reduce
 Duplex Copy
 Tray Use (Tray Selection)
 Brightness
 Contrast
 Stack / Sort
 Page Layout
 2in1(ID)
 Color Adjust (Saturation)
 Set New Default
 Factory Reset
 Favorite Settings
Making copies 4
Enlarge/
Reduce
Quality
Duplex Copy
100% OffAuto
Favorite
Copy