Brother DCP-9270CDN - 3 Loading Documents; How to Load Documents; Using the Automatic Document Feeder (ADF)

25
3
3
How to load
documents
3
You can make copies, and scan from the ADF
(Automatic Document Feeder) and the
scanner glass.
Using the automatic
document feeder (ADF) 3
The ADF can hold up to 50 pages and feeds
each sheet individually. Use standard
80 g/m
2
paper and always fan the pages
before putting them in the ADF.
Document Sizes Supported 3
How to load documents 3
IMPORTANT
• DO NOT leave thick documents on the
scanner glass. If you do this, the ADF may
jam.
• DO NOT use paper that is curled,
wrinkled, folded, ripped, stapled, paper-
clipped, pasted or taped.
• DO NOT use cardboard, newspaper or
fabric.
• To avoid damaging your machine while
using the ADF, DO NOT pull on the
document while it is feeding.
Note
• To scan documents that are not suitable
for the ADF, see Using the scanner glass
on page 26.
• It is easier to use the ADF if you are
loading a multiple page document.
• Make sure documents with correction fluid
or written with ink are completely dry.
a Unfold the ADF document support (1).
Lift up and unfold the ADF document
output support flap (2).
b Fan the pages well.
c Place your document face up top edge
first in the ADF until the LCD display
message changes and you feel it touch
the feed rollers.
d Adjust the paper guides (1) to fit the
width of your document.
Loading documents 3
Length: 147.3 to 356.0 mm
Width: 147.3 to 215.9 mm
Weight:
64 to 90 g/m
2
1
2
1