Brother DCP-J925DW - Sorting Copies Using the ADF; Adjusting Density

Chapter 7
34
d Press d or c to display Page Layout.
e Press Page Layout.
f Press d or c to display 2in1(ID).
g Press 2in1(ID).
h Press Mono Start or Colour Start.
The machine starts scanning the first
page.
i After the machine has scanned one
side, press Yes. Turn over the
identification card and press
Mono Start or Colour Start to scan the
other side.
Note
• Watermark Copy, Book Copy, Sort,
Duplex Copy, Thin Paper Copy,
Ink Save Mode and Enlarge/Reduce
are not available with 2in1(ID).
• If you are producing multiple colour
copies, 2 in 1 (ID) copy is not available.
Sorting copies using the ADF7
You can sort multiple copies. Pages will be
stacked in the order 321, 321, 321, and so on.
a Press (COPY) or Copy.
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Stack/Sort.
e Press Stack/Sort.
f Press Sort.
g If you do not want to change additional
settings, press Mono Start or
Colour Start.
Note
Fit to Page, Page Layout and
Book Copy are not available with Sort.
Adjusting Density 7
You can adjust the copy density to make
copies darker or lighter.
a Press (COPY) or Copy.
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Density.
e Press Density.
f Press d or c to make a lighter or darker
copy.
Press OK.
g If you do not want to change additional
settings, press Mono Start or
Colour Start.