Brother DCP-T300 - Additional Dialing Operations; Dialing Access Codes and Credit Card Numbers

Chapter 5
18
Additional dialing
operations
5
Dialing access codes and
credit card numbers 5
Sometimes, you may want to choose from
several long-distance carriers when you send
a fax. Rates may vary depending on the time
and destination. To take advantage of low
rates, you can store the access codes of long-
distance carriers and credit card numbers as
Speed Dial numbers. (See Basic User’s
Guide: Storing Speed Dial numbers.)
You can store these long dialing sequences
by dividing them and setting them up as
separate Speed Dial numbers in any
combination.
You can even include manual dialing using
the dial pad.
For example, you might have stored ‘555’ on
Address Book: #03 and ‘7000’ on Address
Book: #02. You can use them both to dial
‘555-7000’ as shown in the following
example:
a Press (FAX).
b Press (Libreta (Address Book)).
c Press a or b to choose Search.
Press OK.
d Enter #, 03.
e Press (Libreta (Address Book)).
f Enter #, 02.
g Press Inicio Negro (Black Start).
You will dial ‘555-7000’.
To temporarily change a number, you can
use the dial pad to manually substitute part of
the number. For example, to change the
number to ‘555-7001’, you could enter the
number (#03 ‘555’) using
(Libreta (Address Book)), choose
Search, press OK, press #, 03, and then
press ‘7001’ using the dial pad.
NOTE
If you must wait for another dial tone or
signal at any point in the dialing sequence,
create a pause in the number by pressing
Remarcar/Pausa (Redial/Pause). Each
key press adds a 3.5-second delay. You
can press
Remarcar/Pausa (Redial/Pause) as
many times as needed to increase the
length of the pause.