~
iZJ
PRESSER FOOT
MECHANISM
• In case that presser foot lifter lever 0
is
depressed down, presser foot supporter 0
is
lowered with spring hook
8.
•
Main
presser arm connected with pin 8
is
raised with presser foot supporter
•.
•
If
presser bar lifter 8
is
depressed down
as
per above figure, presser bar lever
8,
presser arm roller shaft
f)
and presser
arm roller
fD
are raised with roller
fD
knocked into presser bar lever
as
a fulcrum presser bar lever shaft
t),
thus main
presser arm
CD
is
released from the pressure
of
presser bar spring e.
4.
DISASSEMBLING
PROCEDURES
[I] COVER
\\
~
bill
®
DCX I
®
CXI3
Procedures
Q'ty
of
Turn the pulley until the needle bar
is
raised to
the highest position, and then turn out presser
foot
0 above needle plate.
screw
2 Remove needles
8.
2
3 Remove cloth plate
• . 2
4 Remove cloth guide (L)
8.
2
-12-
®
®
Q'ty
of
screw
5 Open feed mechanism cover (B)
CD
and remove
feed mechanism cover
(t.
4
6 Remove front cover guide
fj.
2
7 Remove front cover
@).
2
8 Remove front cover supporter
Ci).
2
To Next Page
Loading...
