Brother HL-2270DW - Page 25

25
Macintosh
Wireless Network
Wireless Network
Windows
®
Macintosh
i Choose Temporarily use a Ethernet (LAN)
cable and then click Next.
j Remove the protective cap from the LAN
connector.
k Temporarily connect the Brother wireless
device to your access point using a network
cable (not included) and click Next.
l Choose the machine you wish to configure,
and click Next. If the list is blank, check if the
access point and the machine are powered on,
and then click Refresh.
m The wizard will search for wireless networks
available from your machine. Choose the
access point you wish to associate the
machine with, and then click Next.
Note
• The default node name is “BRNxxxxxxxxxxxx”.
• You can find your machine’s MAC Address
(Ethernet Address) by printing out the Printer
Settings Page. See Print the Printer Settings
Page on page 31.
Note
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the machine and the access point
are within range for wireless communication.
Then, click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Advanced button. Follow the on-screen
instructions for entering the Name (SSID), and
then click Next.