PHOTO 18
Step 15
Set the doctor blade onto the toner
hopper and install the two screws
that hold the doctor blade in place
(See photo 18).
Note: To prevent toner leaks from
the sides of developer roller, the
felts must be fluffy.
© 2008 Future Graphics Imaging Corporation. All
rights reserved. Future Graphics Imaging
Corporation (FGIC) is a distributor of compatible
replacement parts and products for imaging equip-
ment. None of FGIC's products are genuine OEM
replacement parts and no affiliation or sponsorship
is to be implied between FGIC and any OEM.
Step 17
Install the developer roller bearing end cap
onto the side of the toner hopper and install
the Phillips screw that holds it in place (See
photo 21).
PHOTO 19
PHOTO 21
Step 18
Install the tension spring and the white plas-
tic alignment hub to the developer roller
shaft (See photo 22).
PHOTO 22
Step 19
Install the developer roller drive gear to the
driver shaft of the developer roller, Place the
“E” clip onto the drive shaft of the develop-
er roller. Use a needle-nose pliers to snap
the “E” clip back into place (See photo 23).
PHOTO 20
Step 16
Slide in the white bearing tab to the devel-
oper roller drive shaft (See photo 19). Place
the developer onto the toner hopper and
rotate the white bearing tab until it locks into
its position (See photo 20).
PHOTO 23
4 Brother HL-4040CN Technical Instructions
To Next Page
Loading...
