Configuring your printer for a wireless network (For HL-4070CDW)
29
3
i Press OK to enable the wireless LAN interface.
WLAN Enable?
On
Note
After you enable the wireless LAN interface, the wired LAN interface will be set to Off.
j The printer will search for your network.
It will take a few of seconds to display a list of available SSIDs.
Searching SSID
k Select the SSIDs from the list using the + or - button. Press OK to select the SSID.
If the displayed SSID you selected is in infrastructure mode, go to step o.
If the displayed SSID you selected is in ad-hoc mode, go to step p.
If you want to add a new SSID, go to step l.
Select SSID&Set
Brother
Note
If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. Go to
step l.
l Select <New SSID> using the + or - button, and press OK. Go to step m
Select SSID&Set
<New SSID>
m Enter a new SSID using the + or - button. Press OK. Go to step n.
SSID:
_
n Using the + or - button, select Infrastructure. Press OK. Go to step o.
If you select Ad-hoc, go to step p .
Mode Select
Ad-hoc *
Note
For more information on Ad-hoc and Infrastructure mode, see Wireless network connection
example on page 17.
To Next Page
Loading...
