Brother HL-4070CDW - Page 29

Installing the Printer Driver
27
Windows
®
Windows
®
Wireless
Network
6 Choose I’d like to use the
SecureEasySetup™ function of my access
point to configure my wireless device. and
click Next.
7 Confirm the on-screen message and click
Next.
8 Refer to the instruction manual that came with
your access point to use the
SecureEasySetup™ mode of your access
point.
9 Put the printer in SecureEasySetup™ mode
using the control panel.
1 Press any of the Menu buttons (+, -, OK
or Back) to take the printer off-line.
Ready
h
Select ab or OK
Machine Info.
2 Press the + or - button to select LAN.
Select ab or OK
LAN
3 Press OK to move to the next menu
level.
LAN
Wired
4 Press the + or - button to select WLAN.
LAN
WLAN
5 Press OK to move to the next menu
level.
WLAN
TCP/IP
6 Press the + or - button to select
Setup WLAN.
WLAN
Setup WLAN
7 Press OK to move to the next level.
Setup WLAN
Setup Wizard
8 Press the + or - button to select
SecureEasySetup.
Setup WLAN
SecureEasySetup
9 Press OK.
If the following message appears, press
OK again.
WLAN Enable?
On
Note
The message above only appears when the
wireless setting is disabled.
10 The wireless network connection status
using the SecureEasySetup™ software
will be displayed on the control panel;
Connecting WLAN, Connected or
Connection NG.
Connecting WLAN is displayed when
the print server is trying to make
connections to your router or access
point. Wait till either Connected or
Connection NG is displayed.
Connected is displayed when the print
server is successfully connected to your
router or access point. You can now use
your printer in a wireless network.
Connection NG is displayed when the
print server has not successfully
connected to your router or access point.
Try starting from 2 again. If the same
message is displayed again, reset the
print server back to the default factory
settings and try again.