Brother HL-4150CDN - Installing Extra Memory

Option
87
4
Installing extra memory 4
Note
Always turn off the machine power switch before installing or removing the SO-DIMM.
a Turn off the machine power switch, and then unplug the machine. Disconnect all interface cables from
the machine.
b Remove the plastic (1) and then the metal (2) SO-DIMM covers.
c Unpack the SO-DIMM and hold it by its edges.
IMPORTANT
To prevent damage to the machine from static electricity, DO NOT touch the memory chips or the board
surface.
d Hold the SO-DIMM by the edges and align the notches in the SO-DIMM with the protrusions in the slot.
Insert the SO-DIMM diagonally (1), then tilt it toward the interface board until it clicks into place (2).
2
1
12