Brother HL-5040 - Page 134

HL-5030/5040/5050/5070N SERVICE MANUAL
4-37
NOTE:
When re-assembling the paper eject actuator and the eject actuator spring to the FU frame
lower, ensure the paper eject actuator is seated correctly in the locating channel referring to
the figure below;
Fig. 4-65
(28) Disconnect the heater harness.
(29) Remove the four cup B M3x6 Taptite screws.
(30) Remove the four claw holder plate.
(31) Remove the four separate claw ASSY.
Fig. 4-66
Paper eject actuator
Eject actuator spring
FU frame lower
Separate claw ASSY
Separate claw ASSY
Heater harness
Claw holder plate
Taptite, cup B M3x6
Tweezers