Brother HL-5040 - Laser Unit

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-38
3.14 Laser Unit
(1) Remove the filter, and then remove the cup S M3x6 Taptite screw and the air duct.
Fig. 4-67
(2) Disconnect the LD harness 5P from the laser unit.
(3) Disconnect the polygon motor harness and remove the spongy from the laser unit.
(4) Remove the six cup S M3x8 Taptite screws, and then remove the laser unit.
Fig. 4-68
Filter
A
ir duct
Taptite, cup S M3x8
Taptite, cup S M3x8
LD harness 5P
Laser unit
Polygon motor harness
Spongy
Taptite, cup S M3x6