HL-5030/5040/5050/5070N SERVICE MANUAL
6-7
Error message Remedy
Resolution Reduced to
Enable Printing
(The printer has printed the
document at a reduced
resolution)
• Reduce the complexity of your document before you
print to prevent automatic reduction of the resolution.
• Expand the printer memory by adding a commercially
available DIMM memory module.
Toner Empty
• See 1.2 Toner cartridge in Chapter 5.
Toner Low
• Purchase a new toner cartridge and have it ready for
when the Toner Empty status is indicated.
3.2 Error Message Printouts
The printer will report problems by printing an error message as defined in the following table.
Take the corrective actions for the error message.
Error message Remedy
MEMORY FULL
• Press the Go button to print the data left in the printer.
Press the Job Cancel button if you want to delete the
data left in the printer.
• Reduce the print resolution or reduce the complexity of
your document.
• Expand the printer memory by adding a commercially
available DIMM.
PRINT OVERRUN
• Press the Go button to print the data left in the printer.
Press the Job Cancel button if you want to delete the data
left in the printer.
• If this does not clear the error, reduce the complexity of
your document or reduce the print resolution.
• Expand the printer memory by adding a commercially
available DIMM.
• Set page protection to ON by using the supplied
Windows driver or RPC program.
• Change the following settings in the supplied Windows
driver and try again. The best combination of these
settings will vary depending on your document:
Graphics Mode
TrueTypeâ„¢ mode
Use Printer TrueTypeâ„¢ Fonts
RESOLUTION REDUCED TO
ENABLE PRINTING
(The printer has printed the
document at a reduced
resolution)
• Reduce the complexity of your document before you
print to prevent automatic reduction in the resolution.
• Expand the printer memory by adding a commercially
available DIMM.
*NOTE:
The communication parameter settings are printed on the Print Settings sheet. For details on
how to print the Print Settings page, see 2.HOW TO KNOW DRUM UNIT LIFE & PAGE
COUNTER in chapter 7.
To Next Page
Loading...
