CHAPTER 7 SOFTWARE SERVICE SUPPORT
7-16
<PIT3>
6) Move the folder to “PIT3” in DOS window and type “PIT3”, then press ENTER key. PIT3
(software tool) will start.
7) Input model name in PIT3 control window, then press ENTER. “CSXXXX (SCRPTY.YY)”
message appears in the model section of PIT3 control window. *3
8) Input “.VVVVV”, then press ENTER.(.VVVVV expresses a country code. See the detail
below.) *4
ex. If you Input “.00101 (USA version) , “00101 (USA / USA)” message appears in the
specification section of PIT3 control window, and “READY” message appears in the PIT3
status window.
9) Input 9 digit serial number in the PIT3 control window, then press ENTER. PIT3 will be
started, “RUNNING” message appears in the PIT3 status window accordingly.
10) “SER:VVVVVVVVVVVVVVVVVV” message appears in the PIT3 control window, and
“PASS” message appears in ERR CODE section. “READY” message appears in the PIT3
status window. (READY is displayed in about 3 seconds.)
<When the error occurs>
The error generated step appears in the PIT3 control window, error code appears in ERR
CODE section, “ERROR” message appears in the PIT3 status window. To release the
error, Input “check”, then press ENTER.
Please carry out (9) again at the time of error generating. If the error message still
appears, please judge that there is something wrong with PCB.
11) Turn the printer power switch OFF, then disconnect the USB cable.
12) In case of performing the rewriting work to other printers, repeat from the step 2. To finish
working, Input “quit” in the PIT3 control window, then press ENTER key.
*3
MODEL Input Message
HL-5030 /CS5030 CS5030 (SCRPT:Y.YY)
HL-5040 /CS5040 CS5040 (SCRPT:Y.YY)
HL-5050 /CS5050 CS5050 (SCRPT:Y.YY)
HL-5070N /CS5070N CS5070N (SCRPT:Y.YY)
Y,YY expresses a version of script
*4
Code Country HL-5030 HL-5040 HL-5050 HL-5070N
.00101 USA X O O O
.00102 Canada X O O O
.00103 German O O O O
.00104 UK O O O O
.00106 Australia X O O O
.00107 Norway X X X O
.00110 Switzerland O O O O
.00112 Finland X X O O
To Next Page
Loading...
